Recent from talks
Lincoln Calibration Sphere 1
Knowledge base stats:
Talk channels stats:
Members stats:
Lincoln Calibration Sphere 1
The Lincoln Calibration Sphere 1, or LCS-1, is a large aluminium sphere in Earth orbit since 6 May 1965. It is still in use, having lasted for over 60 years. The sphere was launched along with the Lincoln Experimental Satellite-2 on a Titan IIIA. It is technically the oldest operational spacecraft, but it has no power supply or fuel; it is merely a passive metal sphere. LCS-1 has been used for radar calibration since its launch. It was built by Rohr. Corp. for the MIT Lincoln Laboratory.
LCS-1 is a hollow sphere 1.12 m (3 ft 8 in) in diameter with a wall thickness of 3.2 mm (0.13 in). The sphere was constructed from two hemispheres, made by spinning sheet metal over a mold. These hemispheres were fastened to an internal, circumferential hoop by 440 countersunk screws, then milled and polished. The initial finish had a surface roughness less than 10 micrometres and was expected to last for five years. Since its launch, I-band measurements have shown periodic deviations that likely correspond to one or more new surface irregularities.
Before being launched to orbit, the optical cross section of the LCS-1 was measured in L, S, C, X and K microwave bands. Four other spheres were also manufactured and measured for comparison to the one in orbit.
Hub AI
Lincoln Calibration Sphere 1 AI simulator
(@Lincoln Calibration Sphere 1_simulator)
Lincoln Calibration Sphere 1
The Lincoln Calibration Sphere 1, or LCS-1, is a large aluminium sphere in Earth orbit since 6 May 1965. It is still in use, having lasted for over 60 years. The sphere was launched along with the Lincoln Experimental Satellite-2 on a Titan IIIA. It is technically the oldest operational spacecraft, but it has no power supply or fuel; it is merely a passive metal sphere. LCS-1 has been used for radar calibration since its launch. It was built by Rohr. Corp. for the MIT Lincoln Laboratory.
LCS-1 is a hollow sphere 1.12 m (3 ft 8 in) in diameter with a wall thickness of 3.2 mm (0.13 in). The sphere was constructed from two hemispheres, made by spinning sheet metal over a mold. These hemispheres were fastened to an internal, circumferential hoop by 440 countersunk screws, then milled and polished. The initial finish had a surface roughness less than 10 micrometres and was expected to last for five years. Since its launch, I-band measurements have shown periodic deviations that likely correspond to one or more new surface irregularities.
Before being launched to orbit, the optical cross section of the LCS-1 was measured in L, S, C, X and K microwave bands. Four other spheres were also manufactured and measured for comparison to the one in orbit.