Passive nuclear safety

Passive nuclear safety is a design approach for safety features, implemented in a nuclear reactor, that does not require any active intervention on the part of the operator or electrical/electronic feedback in order to bring the reactor to a safe shutdown state, in the event of a particular type of emergency (usually overheating resulting from a loss of coolant or loss of coolant flow). Such design features tend to rely on the engineering of components such that their predicted behaviour would slow down, rather than accelerate the deterioration of the reactor state; they typically take advantage of natural forces or phenomena such as gravity, buoyancy, pressure differences, conduction or natural heat convection to accomplish safety functions without requiring an active power source. Many older common reactor designs use passive safety systems to a limited extent, rather, relying on active safety systems such as diesel-powered motors. Some newer reactor designs feature more passive systems; the motivation being that they are highly reliable and reduce the cost associated with the installation and maintenance of systems that would otherwise require multiple trains of equipment and redundant safety class power supplies in order to achieve the same level of reliability. However, weak driving forces that power many passive safety features can pose significant challenges to effectiveness of a passive system, particularly in the short term following an accident.

'Passive safety' describes any safety mechanism whose engagement requires little or no outside power or human control. Modern reactor designs have focused on increasing the number of passive systems to mitigate risk of compounding human error.

Despite the increased safety associated with greater coverage by passive systems, all current large-scale nuclear reactors require both external (active) and internal (passive) systems. There are no 'passively safe' reactors, only systems and components. Safety systems are used to maintain control of the plant if it goes outside normal conditions in case of anticipated operational occurrences or accidents, while the control systems are used to operate the plant under normal conditions. Sometimes a system combines both features. Passive safety refers to safety system components, whereas inherent safety refers to control system process regardless of the presence or absence of safety-specific subsystems.

An example of a safety system with passive safety components is the containment vessel of a nuclear reactor. The concrete walls and the steel liner of the vessel exhibit passive safety, but require active systems (valves, feedback loops, external instrumentation, control circuits, etc.) which require external power and human operation to function.

The International Atomic Energy Agency (IAEA) classifies the degree of "passive safety" of components from category A to D depending on what the system does not make use of:

In category A (1+2+3+4) is the fuel cladding, the protective and nonreactive outer layer of the fuel pellet, which uses none of the above features: It is always closed and keeps the fuel and the fission products inside and is not open before arriving at the reprocessing plant. In category B (2+3+4) is the surge line, which connects the hot leg with the pressurizer and helps to control the pressure in the primary loop of a PWR and uses a moving working fluid when fulfilling its mission. In category C (3+4) is the accumulator, which does not need signal input of 'intelligence' or external power. Once the pressure in the primary circuit drops below the set point of the spring-loaded accumulator valves, the valves open and water is injected into the primary circuit by compressed nitrogen. In category D (4 only) is the SCRAM which utilizes moving working fluids, moving mechanical parts and signal inputs of 'intelligence' but not external power or forces: the control rods drop driven by gravity once they have been released from their magnetic clamp. But nuclear safety engineering is never that simple: Once released the rod may not fulfil its mission: It may get stuck due to earthquake conditions or due to deformed core structures. This shows that though it is a passively safe system and has been properly actuated, it may not fulfil its mission. Nuclear engineers have taken this into consideration: Typically only a part of the rods dropped are necessary to shut down the reactor. Samples of safety systems with passive safety components can be found in almost all nuclear power stations: the containment, hydro-accumulators in PWRs or pressure suppression systems in BWRs.

In most texts on 'passively safe' components in next generation reactors, the key issue is that no pumps are needed to fulfil the mission of a safety system and that all active components (generally I&C and valves) of the systems work with the electric power from batteries.

IAEA explicitly uses the following caveat: