Recent from talks
Runway excursion
Knowledge base stats:
Talk channels stats:
Members stats:
Runway excursion
A runway excursion is a runway safety incident in which an aircraft makes an inappropriate exit from the runway. This happens mainly due to late landings or inappropriate runway choice.
There are several types of runway excursions:
When an aircraft exits the end of the runway, this is referred to as runway overrun (or informally, runway overshoot). Runway excursions can happen because of pilot error, poor weather, or a fault with the aircraft.
According to the Flight Safety Foundation, as of 2008, runway excursions were the most frequent type of landing accident, slightly ahead of runway incursion. For runway accidents recorded between 1995 and 2007, 96% of runway accidents and 80% of accidents with fatalities involved runway excursions.
Efforts to address runway excursion either focus on preventing runway excursions, or on minimizing the amount of damage or injury caused by a runway excursion. In the latter category, aviation safety regulators may establish standards such as minimum runway safety areas intended to allow adequate time and distance for an aircraft to stop in the event of a runway excursion.
A key aspect of preventing runway excursions is providing runways of sufficient length and width to accommodate the aircraft used at an airport. In the 1960s, the advent of jet airliners such as the Boeing 707, which operate at faster speeds including at takeoff and landing relative to earlier propeller-driven airliners, required longer runways. In the mid-1960s, the Federal Aviation Administration (FAA) proposed increasing minimum runway length requirements by 800 feet (240 m) at all U.S. airports with jet airliner service, extending to 1,200 feet (370 m) feet in rain or snow conditions. However, these requirements would have necessitated building extending runways or even building new airports in some cities. After strong industry response, the FAA withdrew the proposal and instead only mandated a fifteen per cent increase to minimum runway length during wet or slippery landing conditions.
Preventing runway excursions can necessitate building new airports, when there is not room to expand existing runways. On July 1, 1965, Continental Airlines Flight 12 (a Boeing 707) overran the runway while landing in rain and high winds at Kansas City Municipal Airport. Investigators ruled out pilot error, and determined it would have been impossible to stop the aircraft in the available runway length. Extending the 7,000-foot (2,100 m) runway was not possible due to space limitations surrounding the urban airport, and construction on Kansas City International Airport north of the city was approved the next year, opening in 1972 with runways 9,500 feet (2,900 m) and 9,000 feet (2,700 m) in length.
Airports such as LaGuardia Airport in Queens, New York, may lack adequate space to meet runway safety area standards. As a result, in the 1990s, the FAA began conducting research on new technology to rapidly stop aircraft in less than 1,000 feet (300 m) in the event of a runway overrun.
Hub AI
Runway excursion AI simulator
(@Runway excursion_simulator)
Runway excursion
A runway excursion is a runway safety incident in which an aircraft makes an inappropriate exit from the runway. This happens mainly due to late landings or inappropriate runway choice.
There are several types of runway excursions:
When an aircraft exits the end of the runway, this is referred to as runway overrun (or informally, runway overshoot). Runway excursions can happen because of pilot error, poor weather, or a fault with the aircraft.
According to the Flight Safety Foundation, as of 2008, runway excursions were the most frequent type of landing accident, slightly ahead of runway incursion. For runway accidents recorded between 1995 and 2007, 96% of runway accidents and 80% of accidents with fatalities involved runway excursions.
Efforts to address runway excursion either focus on preventing runway excursions, or on minimizing the amount of damage or injury caused by a runway excursion. In the latter category, aviation safety regulators may establish standards such as minimum runway safety areas intended to allow adequate time and distance for an aircraft to stop in the event of a runway excursion.
A key aspect of preventing runway excursions is providing runways of sufficient length and width to accommodate the aircraft used at an airport. In the 1960s, the advent of jet airliners such as the Boeing 707, which operate at faster speeds including at takeoff and landing relative to earlier propeller-driven airliners, required longer runways. In the mid-1960s, the Federal Aviation Administration (FAA) proposed increasing minimum runway length requirements by 800 feet (240 m) at all U.S. airports with jet airliner service, extending to 1,200 feet (370 m) feet in rain or snow conditions. However, these requirements would have necessitated building extending runways or even building new airports in some cities. After strong industry response, the FAA withdrew the proposal and instead only mandated a fifteen per cent increase to minimum runway length during wet or slippery landing conditions.
Preventing runway excursions can necessitate building new airports, when there is not room to expand existing runways. On July 1, 1965, Continental Airlines Flight 12 (a Boeing 707) overran the runway while landing in rain and high winds at Kansas City Municipal Airport. Investigators ruled out pilot error, and determined it would have been impossible to stop the aircraft in the available runway length. Extending the 7,000-foot (2,100 m) runway was not possible due to space limitations surrounding the urban airport, and construction on Kansas City International Airport north of the city was approved the next year, opening in 1972 with runways 9,500 feet (2,900 m) and 9,000 feet (2,700 m) in length.
Airports such as LaGuardia Airport in Queens, New York, may lack adequate space to meet runway safety area standards. As a result, in the 1990s, the FAA began conducting research on new technology to rapidly stop aircraft in less than 1,000 feet (300 m) in the event of a runway overrun.
Recent media