Core sample

A core sample is a cylindrical section of (usually) a naturally occurring substance. Most core samples are obtained by drilling with special drills into the substance, such as sediment or rock, with a hollow steel tube, called a core drill. The hole made for the core sample is called the "core hole". A variety of core samplers exist to sample different media under different conditions; there is continuing development in the technology. In the coring process, the sample is pushed more or less intact into the tube. Removed from the tube in the laboratory, it is inspected and analyzed by different techniques and equipment depending on the type of data desired.

Core samples can be taken to test the properties of manmade materials, such as concrete, ceramics, some metals and alloys, especially the softer ones. Core samples can also be taken of living things, including human beings, especially of a person's bones for microscopic examination to help diagnose diseases.

The composition of the subject materials can vary from almost liquid to the strongest materials found in nature or technology, and the location of the subject materials can vary from on the laboratory bench to over 10  km from the surface of the Earth in a borehole. The range of equipment and techniques applied to the task is correspondingly great. Core samples are most often taken with their long axis oriented roughly parallel to the axis of a borehole, or parallel to the gravity field for the gravity-driven tools. However it is also possible to take core samples from the wall of an existing borehole. Taking samples from an exposure, be it an overhanging rock face or on a different planet, is almost trivial. (The Mars Exploration Rovers carry a Rock Abrasion Tool, which is logically equivalent to the "rotary sidewall core" tool described below.)

Some common techniques include:

Although often neglected, core samples always degrade to some degree in the process of cutting the core, handling it, and studying it. Non-destructive techniques are increasingly common, e.g., the use of MRI scanning to characterize grains, pore fluids, pore spaces (porosity) and their interactions (constituting part of permeability) but such expensive subtlety is likely wasted on a core that has been shaken on an unsprung lorry for 300 km of dirt road. What happens to cores between the retrieval equipment and the final laboratory (or archive) is an often neglected part of record keeping and core management.

Coring has come to be recognized as an important source of data, and more attention and care is being put on preventing damage to the core during various stages of it transportation and analysis. The usual way to do this is to freeze the core completely using liquid nitrogen, which is cheaply sourced. In some cases, special polymers are also used to preserve and seat/cushion the core from damage.

Equally, a core sample which cannot be related to its context (where it was before it became a core sample) has lost much of its benefit. The identification of the borehole, and the position and orientation ("way up") of the core in the borehole is critical, even if the borehole is in a tree trunk – dendrochronologists always try to include a bark surface in their samples so that the date of most-recent growth of the tree can be unambiguously determined.

If these data become separated from core samples, it is generally impossible to regain that data. The cost of a coring operation can vary from a few currency units (for a hand-caught core from a soft soil section) to tens of millions of currency units (for sidewall cores from a remote-area offshore borehole many kilometres deep). Inadequate recording of such basic data has ruined the utility of both types of core.