Far pointer

For example, in an Intel 8086, as well as in later processors running 16-bit code, a far pointer has two parts: a 16-bit segment value, and a 16-bit offset value. A linear address is obtained by shifting the binary segment value four times to the left, and then adding the offset value. Hence the effective address is 21 bits^{[Note 1]}. There can be up to 4096 different segment-offset address pairs pointing to one physical address. To compare two far pointers, they must first be normalized to a form with only one representation address. Such a normalized form may be one that minimizes the segment (maximizing the offset), minimizes the offset (maximizing the segment), or converts the 2-part segmented address to a (20-bit) linear representation. One commonly used normalized form minimizes the offset part of the address to a value less than 16 (10 hex): such a normalization can be computed simply by taking the low-order 4 bits of the unnormalized offset as the new offset, and adding to the unnormalized segment the unnormalized offset shifted right by 4 bits.

On C compilers targeting the 8086 processor family, far pointers were declared using a non-standard far qualifier; e.g., char far *p; defined a far pointer to a char. The difficulty of normalizing far pointers could be avoided with the non-standard huge qualifier. On other compilers it was done using an equally non-standard __far qualifier.^[2]

Example of far pointer:

#include <stdio.h>

int main() {
    char far *p = (char far *)0x55550005;
    char far *q = (char far *)0x53332225;
    *p = 80;
    (*p)++;
    printf("%d", *q);

    return 0;
}

Output of the following program: 81; Because both addresses point to same location.

Physical Address = (value of segment register) * 0x10 + (value of offset).

Location pointed to by pointer p is : 0x5555 * 0x10 + 0x0005 = 0x55555

Location pointed to by pointer q is : 0x5333 * 0x10 + 0x2225 = 0x55555

So, p and q both point to the same location 0x55555.

On some C compilers for ESA/390 and z/Architecture, far pointers can be used to include an identifier of an alternate address space to access.^[3][4] ESA/370, ESA/390, and z/Architecture include facilities for a program running in one address space to access data in another via "access registers".

On larger AVR microcontrollers, addressing more than 64 KB is possible via far pointers, which include an identification of the 64 KB "page" to access.