Anchor

An anchor is a device, normally made of metal, used to secure a vessel to the bed of a body of water to prevent the craft from drifting due to wind or current. The word derives from Latin ancora, which itself comes from the Greek ἄγκυρα (ankȳra).

Anchors can either be temporary or permanent. Permanent anchors are used in the creation of a mooring, and are rarely moved; a specialist service is normally needed to move or maintain them. Vessels carry one or more temporary anchors, which may be of different designs and weights.

A sea anchor is a drag device, not in contact with the seabed, used to minimize drift of a vessel relative to the water. A drogue is a drag device used to slow or help steer a vessel running before a storm in a following or overtaking sea, or when crossing a bar in a breaking sea.

Anchors achieve holding power either by "hooking" into the seabed, or weight, or a combination of the two. The weight of the anchor chain can be more than that of the anchor and is critical to proper holding. Permanent moorings use large masses (commonly a block or slab of concrete) resting on the seabed. Semi-permanent mooring anchors (such as mushroom anchors) and large ship's anchors derive a significant portion of their holding power from their weight, while also hooking or embedding in the bottom. Modern anchors for smaller vessels have metal flukes that hook on to rocks on the bottom or bury themselves in soft seabed.

The vessel is attached to the anchor by the rode (also called a cable or a warp). It can be made of rope, chain or a combination of rope and chain. The ratio of the length of rode to the water depth is known as the scope.

Holding ground is the area of sea floor that holds an anchor, and thus the attached ship or boat. Different types of anchor are designed to hold in different types of holding ground. Some bottom materials hold better than others; for instance, hard sand holds well, shell holds poorly. Holding ground may be fouled with obstacles. An anchorage location may be chosen for its holding ground. In poor holding ground, only the weight of an anchor and chain matters; in good holding ground, it is able to dig in, and the holding power can be significantly higher. The basic anchoring consists of determining the location, dropping the anchor, laying out the scope, setting the hook, and assessing where the vessel ends up. The ship seeks a location that is sufficiently protected; has suitable holding ground, enough depth at low tide and enough room for the boat to swing.

The location to drop the anchor should be approached from down wind or down current, whichever is stronger. As the chosen spot is approached, the vessel should be stopped or even beginning to drift back. The anchor should initially be lowered quickly but under control until it is on the bottom (see anchor windlass). The vessel should continue to drift back, and the cable should be veered out under control (slowly) so it is relatively straight.

Once the desired scope is laid out, the vessel should be gently forced astern, usually using the auxiliary motor but possibly by backing a sail. A hand on the anchor line may telegraph a series of jerks and jolts, indicating the anchor is dragging, or a smooth tension indicative of digging in. As the anchor begins to dig in and resist backward force, the engine may be throttled up to get a thorough set. If the anchor continues to drag, or sets after having dragged too far, it should be retrieved and moved back to the desired position (or another location chosen.)