Hubbry Logo
LNWR Dreadnought ClassLNWR Dreadnought ClassMain
Open search
LNWR Dreadnought Class
Community hub
LNWR Dreadnought Class
logo
8 pages, 0 posts
0 subscribers
Be the first to start a discussion here.
Be the first to start a discussion here.
LNWR Dreadnought Class
from Wikipedia

LNWR Dreadnought class
Type and origin
Power typeSteam
DesignerFrancis Webb
BuilderCrewe Works
Serial number2975–2804, 2886–2905, 3012–3021
Build date1884–1888
Total produced40
Specifications
Configuration:
 • Whyte2-2-2-0
 • UIC1AA n3v
Gauge4 ft 8+12 in (1,435 mm)
Leading dia.3 ft 6 in (1.067 m) + tyres
Driver dia.6 ft 0 in (1.829 m) + tyres
Wheelbase:
 • Engine18 ft 1 in (5.51 m)
 • Leading8 ft 5 in (2.57 m)
 • Drivers9 ft 8 in (2.95 m)
Loco weight43 long tons (44 t)
Boiler:
 • Diameter4 ft 2 in (1.27 m)
 • Tube plates11 ft 0 in (3.35 m)
Boiler pressure175 lbf/in2 (1.21 MPa)
Heating surface1,401.5 sq ft (130.20 m2)
CylindersThree: two HP (outside), one LP (inside)
High-pressure cylinder14 in × 24 in (356 mm × 610 mm)
Low-pressure cylinder30 in × 24 in (762 mm × 610 mm)
Valve gearJoy, Slip-eccentric.
Career
OperatorsLondon and North Western Railway
ScrappedDecember 1903 – July 1905
DispositionAll scrapped

The LNWR Dreadnought class was a class of 40 passenger three-cylinder compound 2-2-2-0 locomotives designed by F. W. Webb for the London and North Western Railway, and manufactured by them in their Crewe Works between 1884 and 1888. The railway also commissioned the Beyer, Peacock and Company to construct an additional locomotive of the design for the Pennsylvania Railroad.[1]

Design

[edit]

The design featured a boiler pressed to 175 lbf/in2 (1.21 MPa) delivering saturated steam to two outside 14-inch (356 mm) high-pressure cylinders, which exhausted to one 30-inch (762 mm) low-pressure cylinder inside the frames. All three cylinders had a stroke of 24 inches (610 mm); the high-pressure cylinders drove the rear wheels, while the low-pressure drove the leading driving wheels. As the two pairs of driving wheels were not connected, the locomotives were "duplex drive" or "double-singles".

They were a development of Webb's Experiment class; they had larger boilers and smaller driving wheels, and while the Joy valve gear for the HP and LP cylinders could still be independently adjusted, it was now also possible to reverse both sets simultaneously. The inside valve gear was subsequently amended to the loose or slip-eccentric system, thus giving automatic reversal.[2]

Decline

[edit]

When George Whale become chief mechanical engineer of the LNWR in 1903, he started a programme of eliminating Webb's over-complicated duplex compound locomotives. Consequently, the class was scrapped between December 1903, and July 1905, having been replaced by Whale's Experiment class.

References

[edit]
Revisions and contributorsEdit on WikipediaRead on Wikipedia
Add your contribution
Related Hubs
User Avatar
No comments yet.