MOS (filmmaking)

MOS is a standard filmmaking jargon acronym used in production reports to indicate an associated film segment has no synchronous audio track.

Omitting sound recording from a particular shot can save time and relieve the film crew of certain requirements, such as remaining silent during a take, and thus MOS takes are common on contemporary film shoots, mostly when the subjects of the take are not speaking or otherwise generating useful sound.

In post-production, a MOS take may be combined with miscellaneous sounds recorded on location, the musical soundtrack, voice-overs, or sound effects created by a Foley artist.

There are many theories regarding the source of the abbreviation "MOS".

When sound recording reached the point where the sound was recorded on a synchronized but separate piece of media (such as 35mm film, audio tape, or other media), a method of keeping the recording media and camera film "in sync" was needed. The solution was to use a special form of motor which has multiple "windings" in it, and which can be connected to another identical motor in such a way that turning one motor a certain distance will turn the other motor exactly the same distance. The motors did not have to be close together, and, with appropriate circuitry, did not have to be of the same size or power. These motors were called selsyn (self synchronous) motors. A system was created by which a single sound recording room could be connected to any of the stages on a studio lot (such connection points are still visible on some of the oldest stages). The production sound mixer on stage connected the control panel to the recording room and the camera. There was a selsyn motor on the camera and it was linked to a matching selsyn motor on the sound recording equipment at another point on the studio lot.

In order to use this system, the sound mixer used an intercom to the sound recordist to tell him to "roll", or start the system. Since this was a mechanical system, it took some time to start the motors and get them up to proper speed. When proper speed and synchronization was reached, the recordist would use the intercom to announce, "Speed" and the sound mixer would relay that to the director and crew on the stage. The expression is still used, but now simply means, "Sound is recording".

It was the recordist who started and stopped the camera motor. The camera operator had a switch to ensure that the camera did not roll at an inopportune time such as loading, replacing lenses, etc. It was also the recordist's duty to stop the motor if something went amiss. The actual power source for the camera motor was in the sound booth.

When a shot was planned that did not require sound, the sound mixer would ask the recordist to "roll the motor only". The recordist would start the camera motor without starting the matching "sound" motor and electronics. The procedure, allegedly, acquired the name "motor only shot", which became the basis of the acronym MOS.