.jpg/2000px-Blackpool_Transport_226_T936EAN_(8803723026).jpg)
Recent from talks
Optare Excel
Knowledge base stats:
Talk channels stats:
Members stats:
Optare Excel
The Optare Excel is a low-floor full-size single-decker bus manufactured by Optare. Manufactured as an integral bus, the Excel was launched in 1995 as one of the first fully low-floor single-deck buses in the United Kingdom, replacing the step-entrance Optare Sigma on Dennis Lance chassis.
Launched in October 1995, the Optare Excel was the manufacturer's first full-size low-floor city bus, built with aluminium and fibreglass panels over a steel frame as opposed to previous Optare products using the Alusuisse system, and featured distinctive Capoco Design styling. Most notably, early Excels included a simple flat panel with embossed Optare lettering set between two pairs of twin headlamps, which was situated below a very large one-piece curved windscreen. Power came from a Cummins 6BT 6-cylinder turbo-diesel engine capable of producing 160 brake horsepower (120 kW), which was mated with a Allison 'World Series' B300R automatic transmission.
The Excel featured a 320 millimetres (13 in) low step at the entrance door, capable of being lowered to 240 millimetres (9.4 in) at the kerbside via the 'kneeling' function of the integrally-built chassis, and the Excel's interior featured a fully-flat floor up to the rear axle, where two steps led to raised rear seats. Built to 9.6 metres (31 ft), 10 metres (33 ft), 10.7 metres (35 ft), 11.5 metres (38 ft) and 11.8 metres (39 ft) lengths, passenger-carrying capacity ranged from between 36 seated and 16 standing to 48 seated and 22 standing.
The Excel was updated in 1999, with the front similar to that of the Optare Solo and with round headlights, two less rear lights, and a repositioned fuel-filler cap. A Mercedes-Benz OM906LA engine was also made available as an option alongside the standard Cummins 6BT.[citation needed]
This updated Excel was known as the Excel 2, which replaced the Delta which by then had finished production. The original Excel was still sold alongside the Excel 2 until it was discontinued by Optare in late 2000. Excel 2s were only built in 10.7 m (35 ft), 11.5 m (38 ft) and 11.8 m (39 ft) configurations.
The Excel 2 was itself replaced by the Optare Tempo upon its launch in October 2004.
The first eight production Excels began to be delivered to Blackpool Transport in May 1996, with orders following from Nottingham City Transport and Reading Buses. Trent Buses were the overall largest operator of Excels and Excel 2s, ordering a total of 112 of the type from 1998 to 2001.[better source needed]
Another major operator of Excels were Reading Buses, who after taking delivery of their first seven in 1997, purchased a further 45 Excels and Excel 2s between 1997 and 2002. Thirty-five Excels were also delivered to Travel West Midlands for use in Wolverhampton in early 1999, while East Yorkshire Motor Services purchased a total of 24 Excels between 1996 and 1999 for services in Kingston upon Hull and Scarborough.
Hub AI
Optare Excel AI simulator
(@Optare Excel_simulator)
Optare Excel
The Optare Excel is a low-floor full-size single-decker bus manufactured by Optare. Manufactured as an integral bus, the Excel was launched in 1995 as one of the first fully low-floor single-deck buses in the United Kingdom, replacing the step-entrance Optare Sigma on Dennis Lance chassis.
Launched in October 1995, the Optare Excel was the manufacturer's first full-size low-floor city bus, built with aluminium and fibreglass panels over a steel frame as opposed to previous Optare products using the Alusuisse system, and featured distinctive Capoco Design styling. Most notably, early Excels included a simple flat panel with embossed Optare lettering set between two pairs of twin headlamps, which was situated below a very large one-piece curved windscreen. Power came from a Cummins 6BT 6-cylinder turbo-diesel engine capable of producing 160 brake horsepower (120 kW), which was mated with a Allison 'World Series' B300R automatic transmission.
The Excel featured a 320 millimetres (13 in) low step at the entrance door, capable of being lowered to 240 millimetres (9.4 in) at the kerbside via the 'kneeling' function of the integrally-built chassis, and the Excel's interior featured a fully-flat floor up to the rear axle, where two steps led to raised rear seats. Built to 9.6 metres (31 ft), 10 metres (33 ft), 10.7 metres (35 ft), 11.5 metres (38 ft) and 11.8 metres (39 ft) lengths, passenger-carrying capacity ranged from between 36 seated and 16 standing to 48 seated and 22 standing.
The Excel was updated in 1999, with the front similar to that of the Optare Solo and with round headlights, two less rear lights, and a repositioned fuel-filler cap. A Mercedes-Benz OM906LA engine was also made available as an option alongside the standard Cummins 6BT.[citation needed]
This updated Excel was known as the Excel 2, which replaced the Delta which by then had finished production. The original Excel was still sold alongside the Excel 2 until it was discontinued by Optare in late 2000. Excel 2s were only built in 10.7 m (35 ft), 11.5 m (38 ft) and 11.8 m (39 ft) configurations.
The Excel 2 was itself replaced by the Optare Tempo upon its launch in October 2004.
The first eight production Excels began to be delivered to Blackpool Transport in May 1996, with orders following from Nottingham City Transport and Reading Buses. Trent Buses were the overall largest operator of Excels and Excel 2s, ordering a total of 112 of the type from 1998 to 2001.[better source needed]
Another major operator of Excels were Reading Buses, who after taking delivery of their first seven in 1997, purchased a further 45 Excels and Excel 2s between 1997 and 2002. Thirty-five Excels were also delivered to Travel West Midlands for use in Wolverhampton in early 1999, while East Yorkshire Motor Services purchased a total of 24 Excels between 1996 and 1999 for services in Kingston upon Hull and Scarborough.
Recent media