Digital subscriber line (DSL; originally digital subscriber loop) is a family of technologies that are used to transmit digital data over telephone lines. In telecommunications marketing, the term DSL is widely understood to mean asymmetric digital subscriber line (ADSL), the most commonly installed DSL technology, for Internet access.

In ADSL, the data throughput in the upstream direction (the direction to the service provider) is lower, hence the designation of asymmetric service. In symmetric digital subscriber line (SDSL) services, the downstream and upstream data rates are equal.

DSL service can be delivered simultaneously with wired telephone service on the same telephone line since DSL uses higher frequency bands for data transmission. On the customer premises, a DSL filter is installed on each telephone to prevent undesirable interaction between DSL and telephone service.

The bit rate of consumer ADSL services typically ranges from 256 kbit/s up to 25 Mbit/s, while the later VDSL+ technology delivers between 16 Mbit/s and 250 Mbit/s in the direction to the customer (downstream), with up to 40 Mbit/s upstream. The exact performance is depending on technology, line conditions, and service-level implementation. Researchers at Bell Labs have reached SDSL speeds over 1 Gbit/s using traditional copper telephone lines, though such speeds have not been made available for the end customers yet.^{[as of?]}

Initially, it was believed that ordinary phone lines could only be used at modest speeds, usually less than 9600 bits per second. In the 1950s, ordinary twisted-pair telephone cable often carried 4 MHz television signals between studios, suggesting that such lines would allow transmitting many megabits per second. One such circuit in the United Kingdom ran some 10 miles (16 km) between the BBC studios in Newcastle-upon-Tyne and the Pontop Pike transmitting station. However, these cables had other impairments besides Gaussian noise, preventing such rates from becoming practical in the field. The 1980s saw the development of techniques for broadband communications that allowed the limit to be greatly extended. A patent was filed in 1979 for the use of existing telephone wires for both telephones and data terminals that were connected to a remote computer via a digital data carrier system.

The motivation for digital subscriber line technology was the Integrated Services Digital Network (ISDN) specification proposed in 1984 by the CCITT (now ITU-T) as part of Recommendation I.120, later reused as ISDN digital subscriber line (IDSL). Employees at Bellcore (now Telcordia Technologies) developed asymmetric digital subscriber line (ADSL) by placing wide-band digital signals at frequencies above the existing baseband analog voice signal carried on conventional twisted pair cabling between telephone exchanges and customers. A patent was filed by AT&T Bell Labs on the basic DSL concept in 1988.

Joseph W. Lechleider's contribution to DSL was his insight that an asymmetric arrangement offered more than double the bandwidth capacity of symmetric DSL. This allowed Internet service providers to offer efficient service to consumers, who benefited greatly from the ability to download large amounts of data but rarely needed to upload comparable amounts. ADSL supports two modes of transport: fast channel and interleaved channel. Fast channel is preferred for streaming multimedia, where an occasional dropped bit is acceptable, but lags are less so. Interleaved channel works better for file transfers, where the delivered data must be error-free but latency (time delay) incurred by the retransmission of error-containing packets is acceptable.

Consumer-oriented ADSL was designed to operate on existing lines already conditioned for Basic Rate Interface ISDN services. Engineers developed high-speed DSL facilities such as high bit rate digital subscriber line (HDSL) and symmetric digital subscriber line (SDSL) to provision traditional Digital Signal 1 (DS1) services over standard copper pair facilities.